Exquisit WA 6010 A+ Manuel D'exploitation page 36

EN
Dispenser drawer
After setting the Wash Program Selector to the mark
program is cancelled.
TEMPERATURE SELECTION
The Machine allows setting the washing temperature below the maximum value provided by the Wash
Program in accordance with recommendations of detergent manufacturers. The temperature indicator (Fig. 3)
has values of the washing temperature and the symbol
water supply.
When selecting the wash program, the temperature indicator highlights the maximum value of wash-
ing temperature. To decrease the washing temperature, press the button
temperature will alternate from the maximum value to the
SPIN SPEED SELECTION
The spin speed indicator shows numerical values of the spin speed – from the maximum value (depend-
ing on the model and program) to the minimum one – and the symbol
wash program, the spin speed indicator shows the maximum value of the spin speed. To decrease the spin
speed, press the button
value to the , and then back.
ATTENTION! The speed of intermediate spins between the basic wash stages is not adjusted and
depends on the selected program.
OPTIONAL FUNCTIONS OF THE MACHINE
To select an optional function, press the button of the needed function – the respective indicator will
go on. After repeated pressing, the light indicator goes out, the function is off.
ATTENTION! When the selected function is incompatible with the set program, the indicator will
not go on and the function will not be off (three audio signals will be heard).
Setting time for delay wash
To set the function, press the button – the time indicator will show the maximum time of delay
wash 24 hours ("24:H"). At long pressing or short repeated pressings of the button, the time will
change with a step of 1 hour down to the minimum value of 1 hour ("1:H"). When the time is not
set, the wash will start immediately after pressing the
Pre-wash
The function is provided for washing of heavily soiled (very dirty) cotton items. When switching
the function on, the items will be washed additionally in the water with detergent at the temperature
of 30 ºC. It ensures a high quality dirt removal during the basic wash.
Soaking
The function is provided for washing heavily soiled (very dirty) cotton items. When switching
the function on, the items will be kept additionally in water with detergent for 1 to 2 hours, and
then washed under a pre-wash program. To cut the time of soaking and start of washing, switch
off the function by pressing the button over again.
36
Display
Wash program selector
Figure 2 – Control Panel
(Fig. 3) – the values of the spin speed are shown alternately from the maximum
START/PAUSE button
, the Machine is switched off and the selected
, indicating the washing temperature in the cold
20 °С
, and then back.
20 °С
(the spin is off). When selecting the
button.
(Fig. 3) – the values of the