Exquisit WA 6010 A+ Manuel D'exploitation page 39

CONNECTING TO WATER SUPPLY AND DRAINAGE
Prior to connect the Machine to water supply, open the tap and let water flow and flush any sand and
rust from water supply pipes.
The Machine is connected only to the cold water supply system through a water supply tap with a
¾-inch threaded branch pipe.
Prior to connect the Machine to the water conduit, open the cock and let the water flow down thus
making washing down the contaminations of sand and rust out off the pipes.
The filling hose of , Machine is equipped with "AQUASTOP" protective system. Check up the filling
hose prior to connect the Machine. Keep an eye on following circumstances: In accordance with Fig. 9, a
yellow-orange color should be seen through the special window; if the color is red, than the hose is out of
service. Connect the filling hose to the threaded branch pipe of the water delivery cock in accordance with
Fig. 9 and to the solenoid-operated value in accordance with Fig. 10 having tightened the nuts by hand.
CAUTION! Do not sink the hose with a system "AQUASTOP" in water.
In the process of washing, the water supply tap should be completely open (Fig. 11).
The draining hose (Fig. 12) should be at least 60 cm and at most 90 cm above the floor level. It this
requirement is not observed, the Machine would not work.
For draining water directly into the sewerage, the draining hose should be fixed above the sewerage
elbow (trap) into the sewerage pipe with internal diameter of at least 40 mm to avoid reverse suction of
drain water into the Machine.
The draining hose may be connected directly to the trap (Fig. 13), if it has a branch pipe for this purpose.
When draining water into the sink or bath the hose (Fig. 14), fix the hose in the bending point by a
special clamp supplied with the Machine. The hose should not be immersed into water.
ATTENTION! After connecting to the water supply and sewerage, the filling and draining hoses
should not be bent or pinched.
After connecting the Machine to water supply and sewerage, check the tightness of the filling hose
connections: the connection points should be dry.
4 MACHINE OPERATION
filtre
Figure 9
Figure 12
1
Figure 10
Figure 13
EN
CLOSED
OPEN
Figure 11
Figure 14
39