Publicité
Les langues disponibles
Les langues disponibles
Keep this device away form rain, moisture, splashing
and dripping liquids.
Protect this device from shocks and abuse. Avoid brute
force when operating the device.
• Familiarise yourself with the functions of the device before
actually using it.
• All modifications of the device are forbidden for safety
reasons. Damage caused by user modifications to the device
is not covered by the warranty.
• Only use the device for its intended purpose. Using the
device in an unauthorised way will void the warranty.
• Damage caused by disregard of certain guidelines in this
manual is not covered by the warranty and the dealer will
not accept responsibility for any ensuing defects or
problems.
4.
Mounting instructions
Refer to the illustrations on page 2 of this manual.
Connection diagram
1
input
2
adapter DC 12V
3
speaker
4
selector
• Mount the included mounting bracket on a sidewall or
another suitable surface at ± 60cm above the ground.
Note: make sure passers-by can not accidentally bump into
it.
• Attach the sensor [9] to the mounting bracket.
• [A] Connect the sensor [9] to the speaker [3].
• [B] Connect the speaker [3] to the mains using the included
adapter [2].
• [C] Set the selector [4] to CHIME.
• [D] Use the included screwdriver to set the timer and
volume of the speaker. Do not force or use any other
screwdriver.
• [E] Locate the best position for the reflector [8] by moving it
against the wall opposite the sensor until the chime stops
and the red alignment LED on the senor is on. Distance must
be at least 50cm and maximum 7m (depends on
04.06.2010
Keep this device away from dust and extreme
temperatures.
PEM7D
5 output
6 optional* counter PEM7D/C
7 IR beam
8 retro reflector
9 photoelectric beam sensor
4
Rev. 01
* Not incl.
©Velleman nv
Publicité
