Installation - Masterflex L/S 07519-10 Notice D'utilisation

MODELS 07519-15 & 07519-25
CARTRIDGE
PUMP
HEAD
OCCLUSION
WEDGES
Tool Required: Long hex key (provided).
Mount the Pump Head to a MASTERFLEX
1. Connect the Pump to Drive by aligning the tang on Pump Head (see Figure 2) with the slot in the motor Drive shaft.
2. Attach Pump Head to drive unit with four screws (provided) using the long hex key (also provided).
3. If the Pump Head requires support, install the appropriate length support screw with plastic foot and locknut (three
provided). Level the Pump Head with the drive unit by adjusting the foot. Tighten the locknut against the bottom of the
pump body.
5:1 SPEED REDUCTION
MODELS 07519-15
07519-25
OCCLUSION
ADJUSTMENT
FIGURE 1 PUMP HEADS WITH CARTRIDGES

INSTALLATION

® ®
L/S Pump Drive as follows:
FIGURE 2 PUMP MOUNTING
MODELS 07519-10 & 07519-20
4