Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Storing Information About CDs (Custom Files)
Deleting discs from a group
1
Before you start playing, select the play mode by
pressing CONTINUE or SHUFFLE.
2
Turn the JOG dial to select the disc which you
want to delete from a group.
3
Press one of GROUP 1 – 8 to select a group.
The group number appears in the display.
4
While the group number is lit in the display, press
ERASE.
"FILE ERASE" appears, and the group number
indication disappears from the display.
Storing Information About CDs (Custom Files)
Locating a Scene or Track You Want
Additional Information
Storing Information About CDs (Custom Files)
Locating a Scene or Track You Want

Precautions

On safety
• As the laser beam used in this unit is harmful to the eyes,
do not attempt to disassemble the cabinet. Refer servicing
to qualified personnel only.
• Should any solid object or liquid fall into the cabinet,
unplug the player and have it checked by qualified
personnel before operating it any further.
On power sources
• Before operating the player, check that the operating
voltage of the player is identical with your local power
supply. The operating voltage is indicated on the nameplate
at the rear of the player.
• The player is not disconnected from the AC power source
(mains) as long as it is connected to the wall outlet, even if
the player itself has been turned off.
• If you are not going to use the player for a long time, be
sure to disconnect the player from the wall outlet. To
disconnect the AC power cord (mains lead), grasp the plug
itself; never pull the cord.
• AC power cord must be changed only at the qualified
service shop.
On placement
• Place the player in a location with adequate ventilation to
prevent heat build-up in the player.
• Do not place the player on a soft surface such as a rug that
might block the ventilation holes on the bottom.
• Do not place the player in a location near heat sources, or in
a place subject to direct sunlight, excessive dust or
mechanical shock.
On operation
• If the player is brought directly from a cold to a warm
location, or is placed in a very damp room, moisture may
condense on the lenses inside the player. Should this occur,
the player may not operate properly. In this case, leave the
player turned on for about an hour until the moisture
evaporates.
On adjusting volume
• Do not turn up the volume while listening to a portion with
very low level inputs or no audio signals. If you do, the
speakers may be damaged when a peak level portion is
played.
On cleaning
• Clean the cabinet, panel and controls with a soft cloth
slightly moistened with a mild detergent solution. Do not
use any type of abrasive pad, scouring powder or solvent
such as alcohol or benzine.
EN
21

Publicité

Table des Matières
loading

Table des Matières