Connection (Rechargeable Batteries) - Teac R-5DAB Mode D'emploi

Connection (Rechargeable Batteries)

About rechargeable batteries
The R-5DAB uses a Nickel-Metal-Hydride battery
pack stored in the battery compartment.
Leaving the AC adaptor connected to the
R-5DAB and plugged into an AC line, ensures
the batteries will be fully charged when you
need to use the R-5DAB on battery power. The
R-5DAB can be used for 5 hours after batteries
are fully charged.
< When the R-5DAB is not being used but the
AC adaptor is plugged in, the batteries will
be completely charged within approximately
3.5 hours from a full discharge.
< When the R-5DAB is ON and the AC adaptor
is plugged in, the batteries will be completely
charged within approximately 24 hours.
< It may take up to 4 charge and discharge
cycles before the batteries are operating at
full capacity when the R-5DAB is new or left
unused for several weeks.
It is suggested that the R-5DAB be plugged
in for about 12 hours before you use it for the
first time.
6 6
< Once the R-5DAB has been fully charged
while it is in STANDBY, do not unplug the AC
adaptor and then immediately plug it again.
This will restart the charging cycle even
though the batteries are fully charged. Doing
this repeatedly will damage the batteries.
< If the R-5DAB is not plugged in, the batteries
will slowly discharge.
< The cycles of recharging the Nickel-Metal-
Hydride battery pack diminish the battery's
capacity. It is called "Memory effect". To
prevent this, sometimes the battery must be
discharged before you recharge it.