Publicité
Les langues disponibles
Les langues disponibles
1.2 Height adjustment
To decrease desk height:
| Press and hold the "down" button
until the desired height is reached.
The "down"/"up" movement of the desk will continue until you release the button or until the
lowest/highest possible position is reached.
On uneven floor, use glides to level the workstation before adjusting its height.
2.
Control panel functions: control panel with a display and a memory function
2.1 System initialisation / First start-up
To ensure correct operation, the workstation base needs to be initialised before first use.
| Press and hold the "down" button until the workstation reaches its lowest position, then
release the button.
During the initialisation procedure, the
The same function applies if the wires connecting the columns with the control module have
been disconnected, or when a height setting error has occurred in an end position, or when
the actual height is not aligned with the height shown on the display. If the control module is
forcing initialisation, the workstation can only move "down" at slow speed.
Releasing the button too early may cause the workstation to malfunction. If this happens, the
initialisation procedure must be repeated.
To increase desk height:
| Press and hold the "up" button until the
desired height is reached.
symbol will be shown on the display
EN 7
Publicité
