Nowy Styl eModel 2.0 Guide D'utilisation page 6

1. Control panel functions: the up/down adjustment button
1.1 System initialisation / First start-up
To ensure correct operation, the workstation base needs to be initialised before first use.
| Press and hold the "down" button until the workstation reaches its lowest position, then
release the button.
The same function applies if the wires connecting the columns with the control module have
been disconnected. If the control module is forcing initialisation, the workstation can only move
"down" at slow speed.
Releasing the button too early may cause the workstation to malfunction. If this happens, the
initialisation procedure must be repeated.
6 EN
Note: Use only the control module provided by the manufacturer
for each specific product type. The adjustment range limits have
been set at the factory.
Danger: The anti-collision function is not active during an initialisa-
tion or reset procedure. Please always be mindful of a potential risk
of crushing during those procedures.