Troubleshooting; Warranty - Dometic PERFECTVIEW VT 100DIG Instructions De Montage Et De Service

VT100DIG
9

Troubleshooting

Fault
The monitor displays the
message "NO SIGNAL".
The monitor displays the
message "REVERSE
FOR IMAGE".
The monitor displays the
message "Pairing
Failed".
The monitor displays the
message "wait for
TX".
Irregular image playback
or yellow warning triangle
on the screen.
10

Warranty

The statutory warranty period applies. If the product is defective, please contact the
manufacturer's branch in your country (see the back of the instruction manual for the addresses) or
your retailer.
For repair and guarantee processing, please include the following documents when you send in
the device:
• A copy of the receipt with purchasing date
• A reason for the claim or description of the fault
EN
Cause
The transmitter module is
not working.
The green and the blue
cable are incorrectly con-
nected.
The transmitter module is
not receiving a video sig-
nal.
The start signal (on/off
three times) is incomplete
or missing.
Transmitter and receiver
modules have lost identi-
fication.
The transmitter module
has no voltage supply.
–
Suggested remedy
Check the voltage supply.
Check the camera connection and
function.
Repeat the system pairing until the
monitor displays "Save data".
Engage reverse gear again.
Start system pairing.
Check the voltage supply.
Make sure that the antennae of the
receiver module and the transmitter
module are firmly connected.
Check the reception bars on the moni-
tor. If only one reception bar is dis-
played, change the position of the
transmitter or receiver module.
Check if the battery charge is sufficient.
Troubleshooting
17