inventiv INV B4046 T2B Notice Originale D'utilisation page 86

Spare parts/Replacement parts
The following parts of this product may be replaced by the consumer. Spare parts are
available at an authorized dealer or through our customer service.
Description
Battery Charger
Battery pack
Grass catcher
Cutting device (blade)
Underbody and cutting device
WARNING!
Wear safety gloves when working on the cutting device and close
to it! Use proper tools to remove debris, e. g. a wooden stick!
Never use your bare hands!
Always use original spare parts for replacement. Replace the
cutting device only with an identical component carrying the part
number SMV 8820223 as mentioned above. Do not attach any
other type of cutting device!
The replacement of the cutting device should be done by an
experienced user!
Rework or sharpening blades is not recommended unless it is
done by a repair service or a similarly qualified specialist!
1. Keep the underbody and cutting device clean and free of debris. Remove
clippings from the discharge chute
2. Check all nuts and bolts periodically for tightness before operation. After
prolonged use, especially in sandy soil conditions, the cutting device will become
worn and lose some of the original shape. The cutting efficiency will be reduced
and the cutting device should be replaced.
3. Keep the cutting device sharp to ensure a good cutting performance. Replace
a worn or damaged cutting device with a new one of the same type or have it
sharpened by a qualified specialist.
4. Loosen the bolt (19) anticlockwise using a suitable wrench and remove it
together with cutting device (20)
Model no. or Specification
B0Q136-AB
INV BAT2 (10INR19/65-2) 5Ah
SLM40K.0.2A
SMV 8820223
86