inventiv INV B4046 T2B Notice Originale D'utilisation page 77

NOTE!
your power tool for the first time, fully recharge the battery.
NOTE!
storage.
For charging, the battery temperature must be within the specified temperature range.
See section "Technical Data" for reference.
1. Connect the charger to an electrical outlet. The indicator light (14) will turn a
steady green, which shows the charger is ready for charging.
2. Insert the battery pack into the charger. The indicator light (14) will start flashing,
which means charging is in process. The indicator lights (16) on the battery to
display remaining battery charge will also ignite. .
3. When fully charged, the indicator lights (16) on the battery will all ignite briefly and
then shut down. The indicator light (14) on the charger will stop flashing and turn
into a steady green again.
4. Insert the battery pack into the charger and then the LED light will be flashing,
which means during the charging processing. And at the same time 4 LED on
battery pack is flowing lighting.
5. When fully charged the 4 LED will be all light for 3 seconds and shut down. And
the LED on charger stops flashing and keeps on
Indicator lights on the charger
a. When the charger is plug on with no battery inside, the indicator light shows a
steady green light.
b. While a battery is being charged, the indicator light will flash green.
c. A steady green indicator light shows that the inserted battery is fully charged.
d. In cals of any problems, the indicator light will flash red. . If any problems the red
LED will be flashing.
The battery is supplied partially charged. Before using
To increase battery life, fully recharge the battery before
14 16
77