inventiv INV B4046 T2B Notice Originale D'utilisation page 85

Maintenance
WARNING!
from the power supply and let the product cool down before
performing inspection, maintenance and cleaning works.
- Keep the underbody and cutting blade clean and free of debris. Remove
clippings from the discharge chute.
- Check all nuts and bolts for tightness before operation. After prolonged
use, especially in sandy soil conditions, the cutting blade will become
worn and lose some of its original shape. The cutting efficiency will be
reduced and the cutting blade should be replaced.
- Lubricate the cutting blade after each use to prolong the life span of
the blade and product. Apply light machine oil along the edge of cutting
blade.
WARNING!
Only perform repairs and maintenance work according to these
instructions! All further works must be performed by a qualified
specialist!
General cleaning
1. Clean the product with a dry cloth. Use a brush for areas that are hard to reach.
2. In particular clean the air vents after every use with a cloth and brush.
3. Remove stubborn dust with high pressure air (max. 3 bar).
Note:
Do not use chemical, alkaline, abrasive or other aggressive detergents
or disinfectants to clean this product as they might be harmful to its
surfaces.
4. Check for any damage and wear. Repair damages in accordance with this
instruction manual or take it to an authorized service center before using the
product again.
Always switch the product off, disconnect it
85