Important Safety Instructions; Safety Codes And Standards; Electric Safety - Gaggenau CI 292 600 Notice De Montage

9

IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS
IMPORTANT: The appliance must be installed by a
I M P O R T A N T S A F E T Y I N S T R U C T I O N S R E A D A N D S A V E TH E S E I N S TR U C TI O N S
qualified installer.
INSTALLER: please leave these instructions with this
unit for the owner. Show the owner the location of the
circuit breaker or fuse. Mark it for easy reference.
OWNER: Please retain these instructions for future
reference.
WARNING
If the information in this manual is not followed exactly,
fire or shock may result causing property damage or
personal injury.
WARNING
Do not repair, replace or remove any part of the
appliance unless specifically recommended in the
manuals. Improper installation, service or maintenance
can cause injury or property damage. Refer to this
manual for guidance. All other servicing should be done
by an authorized servicer.
Remove all tape and packaging before using the
appliance. Destroy the packaging after unpacking the
appliance. Never allow children to play with packaging
material.
Hidden surfaces may have sharp edges. Use caution
when reaching behind or under appliance.
This appliance is intended for use up to a maximum
height of 13,100 feet (4,000 meters) above sea level.
Improper installation is not covered by the warranty.
WARNING
Wearers of electronic implants
The appliance may contain permanent magnets which
may affect electronic implants, e.g. heart pacemakers or
insulin pumps. Therefore, during installation, wearers of
electronic implants must maintain a minimum distance
of 4 inch (10 cm) from the appliance.

Safety Codes and Standards

This appliance complies with one or more of the
following Standards:
▯
UL 858, The Standard for the Safety of Household
Electric Ranges
▯
UL 507, The Standard for the Safety of Electric Fans
▯
CAN/CSA-C22.2 No. 113-M1984 Fans and
Ventilators
▯
CAN/CSA-C22.2 No. 61-M89 Household Cooking
Ranges
It is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.

Electric Safety

WARNING
Before you plug in an electrical cord or turn on power
supply, make sure all controls are in the OFF position.
If required by the National Electrical Code (or Canadian
Electrical Code), this appliance must be installed on a
separate branch circuit.
The circuit breaker should have a contact separation of
at least 3 mm on all poles.
Be sure your appliance is properly installed and
grounded by a qualified technician. Installation,
electrical connections and grounding must comply with
all applicable codes.
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned
ON accidentally.
WARNING
IMPROPER GROUNDING CAN RESULT IN A RISK OF
ELECTRIC SHOCK
Consult a qualified electrician if the grounding
instructions are not completely understood, or if
doubt exists as to whether the appliance is
properly grounded.
CORD.
DO NOT USE AN EXTENSION
3