Ferm CTM1010 Traduction De La Notice Originale page 6

it anticlockwise. Draw the tube out to its
maximum height and secure it by turning the
tube clockwise. The height of the suspension
bracket is adjustable by loosening the black
knob. After adjusting the suspension bracket
to the correct height, retighten the knob.
• Attach the Combitool to the suspension
bracket of the stand; this suspension bracket
can be turned 360°.
Accessories for the Combitool
Always check that the maximum rpm of the
accessory is suitable for the maximum speed of
the Combitool.
Grinding stones
Fig. 3
When using a grinding stone the first time, use the
dressing stone to balance it. The dressing stone
can also be used for cleaning the surface or to
give the grinding stone a special shape.
Material
Stone, shell
Steel
Aluminium, brass
Plastic
Felt wheels and tip
Fig. 4
The felt wheels or tip should be screwed on the
mandrel.
Material
Steel
Aluminium, brass
Plastic
Sanding bands and disc
Fig. 5
Material
Wood
Steel
Aluminium, brass
Plastic
Stainless steel brushes and bristle brush
Fig. 6
Material
Stone, shell
Aluminium, brass
6
High speed cutter, Diamond wheel point and
Drill
Fig. 7
Material
Stone, shell
Steel
Aluminium, brass
Plastic
Abrasive disc
Fig. 8
Material
Steel
Aluminium, brass
Plastic
5. MAINTENANCE
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
Speed setting
-
This machine has been designed to operate
+
over a long period of time with a minimum of
+ -
maintenance. Continuous satisfactory operation
-
depends upon proper machine care and regular
cleaning.
Cleaning
Keep the ventilation slots of the machine clean to
prevent overheating of the engine. Regularly clean
the machine housing with a soft cloth, preferably
Speed setting
after each use. Keep the ventilation slots free from
+
dust and dirt. If the dirt does not come off use a
+ -
soft cloth moistened with soapy water. Never use
+
solvents such as petrol, alcohol, ammonia water,
etc. These solvents may damage the plastic parts.
Please clean the tool immediately after use.
Speed setting
Lubrication
+ +
Make sure to lubricate the flexible shaft regularly
-
to prevent excessive heat generation.
+ -
-
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. In the back of this manual you find
Speed setting
an exploded view showing the parts that can be
+ -
ordered.
+ -
Speed setting
Max
+ -
+ +
-
Speed setting
+
+ -
-