Maintenance
Fig. 16: Place new clamp jaws
Visual Inspection
36
Place the new or cleaned clamp jaws in the
•
same position.
ATTENTION!
Make sure that the clamping jaws are aligned and
that the clamping coupling is placed centrally in
the ring.
Replace the housing cover so that the clamp
•
jaws are centred in the ring.
When placing the housing cover make sure
•
that the service lever is facing upwards.
•
Screw the housing cover tightly.
Check the correct installation with a visual
•
inspection:
Look through the shaft entrance: If the operat-
•
ing lever is pressed, the clamp jaws are visi-
ble, if the operating lever is not pressed, they
are not visible.