Working With The Cable Ø 8 Mm / Adapter; After Drain Cleaning - Wohler RM 200 Instructions De Service

4.4 Working with the cable
Ø 8 mm / adapter
Fig. 11: Adapter attached to the RM 200,
locking bolt marked by an arrow
4.5

After drain cleaning

Use adapter with the 8 mm cable for narrow
•
pipes or pipe bends.
• To do so, pull the cable approx. 30 cm out of
the adapter magazine and push it through the
shaft.
Push the adapter magazine into the shaft
•
entrance and lock it with the bolt.
Now work with the 8 mm cable in the same
•
way as with the 16 mm cable.
• Pull the cable out of the tube and clean it with
water.
After using the machine, let it freely rotate for
•
2-3 minutes.
• Flush and dry the cable and augers. Lubricate
them with oil and keep them in a dry place to
prevent rusting.
Operation
EN
33