Extend The Cable - Wohler Rm 200 Instructions De Service

Operation
4.3

Extend the cable

Fig. 9: Release guide hose, locking bolt
marked by an arrow
Fig. 10: Push the extension cable from
the front through the unit into the protec-
tive hose.
32
Option 1:
• If you want to extend the cable, pull the end
out of the guide hose.
• To do so, pull up the locking bolt on the shaft
entrance and pull off the guide hose.
Connect the next cable piece and push the
•
entire cable length back into the guide hose.
Option 2:
When the cable has completely run out of the
•
machine, hold the end of the cable firmly or fix
it so that it cannot disappear into the pipe.
Push another cable piece from the front
•
through the machine into the protective hose
until only approx. 20 cm protrude from the
machine.
Connect the extension cable to the cable that
•
is already in the tube.