Chauvin Arnoux C.A 25 Mode D'emploi page 73

Input a value into the memory as follows :
A/ Write all the digits comprising the required value, without taking into account the
decimal point.
B/ Position the decimal point.
A/ Writing a number without a decimal point
As soon as one of the arrows on the keyboard is pressed the 5 hyphens change
into 5 zeros.
To increase the value of the digit flashing hold
reduce the value, hold
The change up (... 7, 8, 9, 0, 1, 2 ...) or down (... 2, 1, 0, 9, 8 ...) of a digit will
automatically increase or decrease the digits to the left of it.
Example: 1. Display
2. Button
3. Display
A constant press on a button results in automatic repetition. Release the button
when the required digit appears.
If when increasing or decreasing the digits the maximun capacity of the display is
exceeded, the display will again indicate five hyphens.
The
which is to be programmed to the left or the right.
When the digit on the left is active, press
and the previously displayed value is erased from the memory.
The validation of "- - -" cancels the current programming function which can no
longer appear on the measurement display.
To validate, press the
and
key or any other programming key (ex. SCAN).
PRGM
pressed in.
.
.
buttons move the active digit (flashing)
70
pressed in. Also to
to display the five hyphens
.
.