Correct Weighing; Turning Function; Mother/Child Function; Hold Function - ADE M320600-01 Guide D'utilisation

7.2.2 Per key
To switch off the scale, press and hold down the ON/OFF key for about 2 seconds.
The scale will automatically save the last setting used.
7.3

Correct weighing

Begin weighing only when "0.00 kg" and the symbol >0< appear on the display. Do not load the
scale beforehand. Stand as firm as possible on the weighing surface. The weight can be read off
directly after standstill.
7.4

Turning function

To turn the display indication, briefly press the ON/OFF key (<1 second).
7.5

Mother/child function

Switch on the scale with no load. Wait for "0.00 kg" and the symbol >0< to appear on the scale
display.
Press the M/C key. The M/C symbol will appear on the display. Stand as firm as possible on the
scale. The scale will save the weight reading and display "0.00 kg". In addition, the symbol Net will
appear.
Unload the scale. "----" is shown on the display.
Now take a child by the hand and have them step on the weighing surface again.
The weight will be automatically stabilised and the child's weight will be displayed. When unloading
the scale, the blinking weight reading with the symbol Hold will still be displayed.
7.6

Hold function

When the weighing surface is no longer loaded, the weight reading will still be displayed with the
hold function (automatic hold function). When used for the first time, the scale will start
automatically in the hold function.
Switch on the scale with no load. Wait for "0.00 kg" and the symbol >0< to appear on the scale
display. Begin the weighing process.
Briefly press the HOLD key to have the measured weight displayed permanently. The symbol Hold
will appear on the display. The saved weight reading will be displayed blinking. As soon as the
scale has been unloaded, the weight reading will remain on the display for 90 seconds. Press the
HOLD key again to exit the hold function.
7.7

Tare function

The tare function does not take into account any additional weight placed on the scale.
Switch on the scale with no load. Wait for "0.00 kg" and the symbol >0< to appear on the scale
display. Place the additional weight on the scale and briefly press the TARE key. The display will
blink temporarily and then "0.00 kg" will appear on it. The symbol Net will light up on the display.
Now remove the additional weight from the scale. "----" is shown on the display. Step on the scale
with the additional weight (for example, clothing). The scale will measure the weight of the person
on it without taking the additional weight into account. You can now use the scale as often as you
wish; the saved value will always be deducted as long as the scale is not switched off.
Press the Tare key again to exit the tare function.
Page 30 of 120 M320600-01+02-210429-Rev004-UM-en