Earth Connection; Technical Data - asecos APA.145.75 Mode D'emploi

13. Earth connection

If the hazardous material workplace is placed on a conductive base (e.g. metal bench), the cabinet must be earthed to
the existing earth connection (M5). This is situated on the rear wall above the exhaust air fan.

14. Technical data

The figures in the table are provided as a guide, and are not to be used in the sense of assured properties.
Technical data
External dimensions
Hight
Width
Depth
Internal dimensions
Clear height between
working area and inner
lining
Width
Depth
Usable working areas
Width
Depth
Max. total load on
working area
Sump volume
Total weight
Sound level
Service conditions
Operating temperature
Climatic resistance
Rec. volumentric flow
(acc. to DIN EN 14175-3)
Loss of device pressure
Electrical
Supply voltage
2 earthed sockets
1 energy saving lamp
1 On/Off switch
1 electronic monitoring unit,
battery buffered
1 exhaust air fan
The figures conform to the state of the art as and when these operating instructions were printed.
Changes to these values without notice as a result of further technical development are explicitly permitted.
18
Hazardous material workplace 750 wide Hazardous material workplace 900 wide
1450 mm (from top edge of bench top/
support frame)
750 mm
600 mm
924 mm
740 mm
440 mm
680 mm
440 mm
200 N on area 120 x 120 mm acc. to
DIN 12924-4
5 l
70 kg
53,5dB (A)
15–40° C
70% rel. humidity without condensation
330 m 3 /h
315 Pa
85–264 VAC, 47–63 Hz
230 V/16 A
18 W
230 V/50 Hz, 137 W, 2000 rpm
1450 mm (from top edge of bench top/
support frame)
900 mm
600 mm
924 mm
890 mm
440 mm
820 mm
440 mm
200 N on area 120 x 120 mm acc. to
DIN 12924-4
6 l
77 kg
53,5dB (A)
15–40° C
70% rel. humidity without condensation
330 m 3 /h
315 Pa