Bibby Scientific Stuart SMP30 Mode D'emploi page 8

6. Use the Enter key to select "EXIT". This will
cause the display to show the current action
of the SMP30; "COOLING TO AMBIENT".
Once the SMP30 has returned to ambient
temperature, the screen will automatically
display the main menu.
7. Pressing the Enter key again to select "EXIT"
during the cooling program will return the
instrument to the main screen instantly.
Note:- Temperature values remain in the
memory until another melt cycle is initiated
with the "Start Ramp" instruction. The
instrument does not need to be connected
to an electrical supply to maintain the
storage of the recorded results.
5.7 Changing the Instrument Settings
Access to the instrument settings menu is only
available when initially switching on the SMP30.
The following instrument settings can be
changed by accessing this menu.
Plateau alarm
Head up display
Displayed language selection
Time and date adjustment
Preset program method settings
1. Ensure that the electrical supply to the
instrument is connected but the instruments
power switch is switched off.
6
2. Whilst switching the power on hold the
3. The SMP30 will display the following
ALARM AT PLATEAU : ON
CHANGE?
EXIT
Use the upper and lower menu keys next to
"YES" and "NO" to select whether to edit the
Alarm at Plateau setting. Selecting "YES" will
ON/OFF
show a screen with options for that particular
ON/OFF
setting and "NO" will move the screen on to
English,
the next parameter.
Spanish,
French, Italian
If "YES" is pressed, the required upper and
or German
lower menu keys should be selected to
determine that setting e.g. Alarm at Plateau
hh:mm and
"ON" and "OFF", using the upper or lower
dd:mm:yyyy
menu key and then"DONE" should be selected
Default
via the Enter key to move to the next
plateau
instrument setting.
temperature
and ramp
For the language option the screen will show
rate
"CHANGE TO SPANISH?". Selecting the upper
menu key selects Spanish as the language and
the lower menu key moves the display on to
the next language. At any point selecting
"DONE" via the Enter key moves the screen on
to the next instrument setting.
Use the Enter key to select "EXIT" and return
to the instrument's main menu.
upper menu key, highlighted in the figure
below.
screen:
m e l t i n g p o i n t SMP30
YES
NO