Connection To Input2; Connection To Input3; Connection To Input4 - Pioneer Elite PRO-1010HD Mode D'emploi

Installation and Connections

Connection to INPUT2

Connect an AV component with a digital video output
(digital set top box, DVD player, etc.) compatible with
HDCP (High-bandwidth Digital Content Protection).
Before attempting to connect one of these components,
read its operating instructions to make sure that it can be
connected.
AUDIO INPUT2
R L
HDMI
AV component with a
digital video output
After connection is made, on-screen setup is necessary
to match the connected component. Please see page 25
to 27.
Notes
÷ Use a HDMI (High Definition Multimedia Interface) cable for
connection.
÷ When connecting a component with DVI connector, use an
DVI / HDMI conversion cable to make a connection.
÷ It is not a jack intended to be used with a personal computer.
÷ See appendix 1 (page 52) for information regarding signal and
display formats supported by INPUT2.

Connection to INPUT3

Connect an AV component that has S-video output jack to
S-VIDEO (INPUT3) jack.
INPUT3
S-VIDEO
16
EN
AV component

Connection to INPUT4

Connect an AV component that has a video output jack to
INPUT4 jack. The VIDEO OUT (INPUT4) jack can be used
to output the video signal to a separate monitor, recording
device or other component with video input capability.
Note
A video signal will not be output from the VIDEO OUT (INPUT4)
jack when the main power of this display is off or in standby
mode.
INPUT4
VIDEO
IN OUT
To a monitor or a
recording device
AV component