Pioneer Elite PRO-1010HD Mode D'emploi page 18

Installation and Connections
When connecting to ANALOG RGB IN (INPUT1)
ANALOG RGB IN
AUDIO
INPUT1
INPUT1
D-Sub
R L
HDMI
Connect the cable corresponding to the shape of the
input terminal on the display and the personal computer's
output terminal.
Secure by tightening the terminal screws on both units.
When using D-sub INPUT for INPUT1, select [D-sub] in
[INPUT1 SELECT] in the menu (page 23).
Note
You cannot simultaneously use the HDMI INPUT and this INPUT.
On-screen setup is necessary after connection.
Please see pages 23 to 25.
Note
Depending on the type of computer model being connected, a
conversion connector or adapter etc. provided with the computer
or sold separately may be necessary.
For details, please read your PC's instruction manual or consult
the maker or nearest dealer of your computer.
Connection of G ON SYNC analog RGB source
Make G ON SYNC connections for a personal computer
with output that has the synchronization signal layered on
top of the green signal.
When connecting to ANALOG RGB IN (INPUT1)
ANALOG RGB IN
AUDIO
INPUT1
INPUT1
D-Sub
R L
14
EN
HDMI
When using D-sub INPUT for INPUT1, select [D-sub] in
[INPUT1 SELECT] in the menu (page 23).
Note
You cannot simultaneously use the HDMI INPUT and this INPUT.
On-screen setup is necessary after connection.
Please see pages 23 to 25.
When connecting to ANALOG RGB (INPUT5)
ANALOG RGB
G(ON SYNC) B R HD (H/V SYNC) VD
On-screen setup is necessary after connection.
Please see pages 23 to 25.
Note
When making G ON SYNC connections, do not make any
connections to the VD or HD jacks. If connections are made, the
picture may be not displayed normally.
INPUT5