REBER 10025 N Notice D'utilisation Et Entretien page 11

UNPACKING
Open the cardboard box, take off the machine in two persons and place on a plane support.
DIRECTIVE 2002/96/CEE
At the end of his working life the product must not be disposed as urban waste. It must be taken to a special local authority differentiated waste
collection center or to a dealer providing this service.
INSTALLATION
The surface where the machine has to be installed must take into consideration the support dimensions. Furthermore, it must be smooth, dry, strong
and with an height from the ground of about 80 cm. and with around the necessary space for use and maintenance.
The machine must be located on a plain surface and positions which can produce the falling of the machine must be avoided.
Environmental conditions :
Minimum temperature +10° - Max. temperature + 38°
Minimum moisture 30% - Max. moisture 80%
ELECTRICAL CONNECTION
Preliminary controls
Before connecting the machine to power supply, take care of the following:
-
Make sure the socket is provided with a suitable ground protection
-
Make sure that the voltage and frequency of supply correspond to those indicated on the data plate of the machine
-
To operate, the appliance must be connected to a power point that is always easily accessible during use
-
Make sure that the way how the power cord is placed will avoid the possibility of sliding and tripping
-
It is user's responsibility to ensure that the connection of the machine to the electric system is in compliance with the rules in force in the
country where the machine is installed, and to ensure that a correct installation is made by a qualified technician.
-
Once all preliminary controls done correctly, use the main power switch to start using your machine
Three Phase models (reference ending with "380") : electrical connection to the fixed wiring shall mandatorily be done by a duly qualified
-
technician. A suitable all-pole means for disconnection must be incorporated in the fixed wiring in accordance with the local wiring rules.
ELECTRIC SCHEMA 230V / 50Hz
Models : 10026 N -10025 N – 10024 N 10023 N
USING THE ELECTRIC MEAT MINCER
Single Phase models : appliance must be connected to a power socket always easily accessible
during the use. Before any intervention on the appliance place the switch on the "Stop" (-0-)
position and unplug the power cord from the socket.
Three Phase models : appliance must be connected to the fixed wiring in the presence of a suitable
means for disconnection as indicated above. Before any intervention on the appliance place the
switch on the "Stop" (-0-) position and open the applied disconnection means.