REBER 10025 N Notice D'utilisation Et Entretien page 10

- Appliances may only be used by persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and if it is ensured they fully
understand the hazards involved.
DESIGN RULES
This product has been designed to satisfy the standards and Directives required in EU in relation with CE Marking, complying in particular with the
requirements of EU Directives 2014/35/EU (Low Voltage), 2014/30/EU (EMC) and 2011/65/EU (ROHS)
IMPORTANCE OF THE HANDBOOK
The handbook is integral part of the machine. It includes important information regarding safety and warnings pointed with those symbols
The included information will allow you to use the machine in perfect safety conditions and to preserve performances
WARRANTY
The supplier restricts himself to repair or replace all components should have constructions faults in the first 12 months from the date of installation
and however not later than 18 months from the shipment date. Components subjected to normal wearing are excluded from warranty. The costumer
must indicate to the supplier, in order du benefit from the warranty, the faults pointing out, the serial number of the machine, the purchase date (from
invoice), and furthermore he will have to send the faulty part at his charges for reparation or replacement. The supplier fulfils completely his warranty
obligations by the reparation or replacement of the faulty pièce. If reparation is requested on the machine installation location, all charges regarding
labor, trip and hotel fees of the technicians will be entirely at the purchaser charges. The damages due to an inappropriate use, missed maintenance,
tampering are not included in the warranty.
WARNING AND RULES
Read carefully all instructions before using the machine, taking particular care of the paragraphs with the safety and danger symbols.
Remove the plug before all maintenance and cleaning operations
WARNING FOR USE
The manufacturer declines all responsibility in case of improper use of the machine
Check the power cord periodically, if damaged replace it with a power cord same as the one
-
provided; replacement must be done by qualified technician.
The geared motor is supplied as standard with the right amount of oil necessary for its
-
proper operation. It is a long-life oil suitable for occasional food contact, it is not subject to
deterioration or consumption due to machine operation, and must NOT be replaced
"Reber" electric meat choppers are fitted for operation with plates having holes of diameter
-
from 3 mm to 8 mm. Reber snc decline all liability concerning damage or accidents deriving
from using plates having holes of diameter greater than 8 mm.
Never remove the ring nut during the functioning of the meat mincer.
-
Blades are sharp. Handle them carefully
-
Never feed food or dough by hand. Always use food pusher
-
Do not use fingers to scrape food away from discharge disc while appliance is operating.
-
Cut type injury may result.
Do not immerse the electric motor in water or other liquids for cleaning
-
Do not remove the plug from the socket gripping the power cord
-
Do not use extension cords
-
Do not use the machine with wet hands or bare feet
-
Disconnect the plug from the socket before cleaning or maintenance
-
TRANSPORT – HANDLING – STORAGE
The machine is pace in a cardboard box with protection plugs.
The package is proper to travel by all means of transport.
It can be put a carton on another carton for a maximum of 5 cartons
The package must be stored in a dry and no dust place.
When on pallets, handle by transpallet or electric lifter.