Assembling The Device; Screws; Step 1: : Mounting The Base On The Base Crossbar - Fitmaxx Z 02678 KD Mode D'emploi

Assembling the device

ATTENTION!
❐ Set up the device in a suitable area with adequate space on all sides.
❐ Before assembling the device, spread out a blanket or tarp to protect your fl oor.
• To facilitate assembly, a parts list and graphic overview of the all screws, nuts, and
washers including their respective part numbers from the parts list are provided in the
chapter "Product contents". The numbers provided in the fi gures of this chapter also
refer to the "No." category on the parts list. In addition, you will fi nd an overview in the
section „Screws" of the screws and nuts needed in each step to assemble the device.
• Use the supplied tools (16+45) for tightening the screws and cap nuts.

Screws

In the following picture you can see the fastening material needed to assemble the device:

Step 1: : Mounting the base on the base crossbar

Screw the base (28) onto the base cross-
bar (44) using the square neck screws
(37), the curved washers (39), and the
cap nuts (40).
27