Prior To Fi Rst Use; Unpacking The Device; Inserting/Changing The Battery - Fitmaxx Z 02678 KD Mode D'emploi

34 Nylon nut
35 Spring
36 Hexagon socket screw
37 Square neck screw
38 Rear crossbar
39 Curved washer
40 Cap nut
41 Crosshead screw
42 Hexagon socket screw
43 Front crossbar
44 Base crossbar
45 Open-end wrench for fastening cap nuts
46 O-ring
47 Screw cover
48 Pipe cover
49 Bolt
Prior to fi rst use
Before using the device for the fi rst time you must:
• Unpack the product contents,
• Insert the batteries in the workout computer,
• Assemble the device.

Unpacking the device

ATTENTION!
❐ Keep children and pets away from the packaging. Danger of suffocation exists!
Unpack all parts and make sure that the product contents are complete (see chapter
"Product Contents and Product Overview") and check for any damages from transport.
If you identify damages to the components, do not use them (!), instead contact our cus-
tomer service centre.

Inserting/changing the battery

You will need a 1.5 volt battery, type AA to operate the workout computer.
1. Open the battery compartment on the back of the workout computer.
2. Insert the battery. When inserting a battery, make sure the polarity is correct (+/-).
3. Change the battery as soon as the display begins to diminish.
1
2
2
4
1
6
4
2
2
1
1
1
2
2
2
2
26
M10
M8 x 30 mm
M8 x 40 mm
M8
M8
ST 5.0 x 20 mm
M6 x 50 mm
P6
Ø 20 x 8
M 8 x 20 mm