Parkside PHSL 900 A3 Traduction Des Instructions D'origine page 184

GB IE
Content
Introduction .................................8
Intended Use .................................... 8
Technical Data ..............................9
notes on Safety ...........................9
Symbols and labels on the device ....... 9
Safety instructions for safety goggles ... 9
Transportation ................................. 10
Cleaning and Maintenance .............. 10
Maintenance and storage ................ 10
Waste Disposal and
Environmental Protection ...........10
Guarantee .................................10
Repair Service ............................11
Service-Center ............................11
Manufacturer .............................11
Translation of the original
EU declaration of conformity ...... 48
Introduction
Congratulations on the purchase of your
new device. With it, you have chosen a
high quality product.
During production, this equipment has
been checked for quality and subjected to
a final inspection. The functionality of your
equipment is therefore guaranteed.
The operating instructions constitute
part of this product. They contain
important information on safety,
use and disposal.
Before using the product, familiarise
yourself with all of the operating
and safety instructions. Use the
product only as described and for
the applications specified. Keep this
manual safely and in the event that
the product is passed on, hand over
all documents to the third party.
8
Intended Use
This product is intended for domestic use
as safety goggles in connection with cut-
ting and trimming hedges, bushes, and
ornamental shrubs. Any other use not ex-
pressly permitted in this instruction manual
may result in damage to the safety goggles
and may pose a serious risk to the user.
optical class:
1 Safety goggles are suitable for work
that demands very high visual per-
formance (maximum dioptre devia-
tion +/- 0.06)
The optical class marking on your safety
goggles defines how long the safety
goggles can be used for and specifies the
maximum dioptre deviation.
These safety goggles belong to optical
class 1.
They are therefore suitable for long-term
use
Protection class:
S Enhanced strength
(Drop test with a 43g steel ball from
a 1m height at 5.1m/s)
The mechanical strength of these safety
goggles has been tested by means of a
bullet test with a steel ball and has been
awarded protection class "S" for enhanced
strength.