Sony MDR-DS6500 Mode D'emploi page 26

Symptom
The Dolby PLIIx indicator
does not turn on
The Dolby PLIIx indicator
turns on
The DTS indicator does not
turn on
The battery cannot be
charged
The charging indicator
blinks.
US
26
Additional Information
Cause and remedy

The EFFECT switch on the processor is set to "OFF" or "VOICE (STEREO). "

When the INPUT switch is set to DIGITAL, PCM signal or Dolby Digital
signal is not input.

The EFFECT switch on the processor is set to "CINEMA" or "GAME" mode.

Analog input signal, digital input PCM signal, Dolby Digital signal is input.

The DTS digital output setting on the BD/DVD device (including GAME
device) is set to "OFF. "
Refer to the operating instruction of your BD/DVD device, and change the

DTS digital output setting to "ON. "

Playback signals are not recorded in DTS format.

The audio for the chapter being played is not a DTS signal.

The BD/DVD device does not support DTS format.
Use a BD/DVD device that supports DTS.


Check if the charging indicator turns on. If not, put the headphones on the
processor correctly so that the charging indicator turns on.

The processor's contact pin and headphones' contact point are dusty.
Wipe them with a cotton bud, etc.


The battery cannot be charged.
You are attempting to charge the battery in an environment outside the

recommended temperature range of between 5°C and 35°C (between 41°F
and 95°F). You cannot charge while the charging indicator flashes.
Charge in an environmental temperature of between 5°C and 35°C

(between 41°F and 95°F).