VESTEL VHK60BX Mode D'emploi page 64

iii. Put the chimney on the cooker hood.
iv. Attach the diverter to the chimney with four 4mm x 8mm screws.
v. Move the chimney upward. Attach the inner chimney to the plate with two
4mm x 8mm screws.
• If you have an outlet to the outside, your cooker hood can be connected by means of
an extraction duct (enamel, aluminium, flexible pipe or non-flammable material with
an inner diameter of 150-120mm). NOTICE:
• K eep expansion pipes short and straight.
• D o not reduce the size of the expansion pipe.
• W hen using an expansion pipe, always install the pipe pulled out to minimize
pressure loss.
• Failure to observe these instructions will reduce the performance and
increases noise levels of the cooker hood.
• D o not connect the ducting system of the cooker hood to any existing
ventilation system that is being used for any other appliance.
• T he angle of the bend of the expansion pipe should not be less than 120º.
64 | VESTEL VHK60BX-VHK90BX-VHT60CX and VHT90CX