EHEIM skimmarine100 Mode D'emploi page 16

English
The following sections describe maintenance work necessary for
optimum and fault-free operation. Regular maintenance prolongs
the service life and assures functionality of the skimmer over a long
period.
Cleaning the skimmer
1. Before maintenance work, remove the mains plug of the pump.
2. Hold the skimmer with one hand.
3. With the other hand, move the magnet half with logo on the glass
panel away from the skimmer.
4. Remove the skimmer.
5. Remove the box (⌦B).
6. Loosen the hose and then disassemble the airstone (⌦C/D).
7. Pull the foam cup i away with the cover facing upwards (⌦G1).
8. Open the body by pressing in the two side latches at the same
time (⌦G2).
9. Unfold the body (⌦H).
10. Using a brush, clean all components under a jet of water.
11. Install the skimmer again in reverse order.
When assembling, make sure that the hinge for both halves of the
body interlocks correctly (⌦H).
Changing the lime wood airstone
The airstone must be changed approximately every 4 weeks.
To do so, proceed as follows:
1. Before maintenance work, remove the mains plug of the pump.
2. Hold the skimmer with one hand.
3. With the other hand, move the magnet half with logo on the glass
panel away from the skimmer.
4. Remove the skimmer.
5. Remove the box (⌦B).
6. Loosen the hose and then disassemble the airstone (⌦C/D).
7. Change the airstone
16