EHEIM skimmarine100 Mode D'emploi page 15

English
Installation in the aquarium (⌦E)
1. With one hand, hold the skimmer at the desired position in the
aquarium from the inside.
2. With the other hand, carefully place the magnet half with logo
g onto the glass panel at a distance from the skimmer (from
the outside). Ensure that the magnet does not strike against the
glass panel!
3. Move the magnet half in the direction of the skimmer on the glass
until both magnet halves lie one above the other.
5. Operation
Start position
1. Position the skimmer so that the water level of your aquarium
matches the wavy line h (water level characteristic line) on the
skimmer.
2. Set your air pump to the middle level.
Following initial commissioning, the skimmer must "run in". This can
take up to one week. The skimmer usually starts to produce foam
within the first 2 days. During this time, residual air may escape at
the outlet. This is no cause for concern. Following the running-in
period, no further residual air will escape.
Fine adjustment
You can adjust the skimming performance according to the air volume of the
pump. You can also change the installation height of the skimmer. However,
adjustment according to the air volume is preferred.
6. Maintenance
Attention! Electrocution!
▶ Before maintenance work, remove the mains plug of the pump.
Caution Material damage.
▶ Do not use hard objects or cleaning agents for cleaning.
15