Dirt Devil VAPORFLEX M3101 Mode D'emploi page 28

3 Operating
1
2
2
3
1
28
NOTE:
The steam cleaner has an overheating protection device.
It turns off automatically if it overheats. If this happens,
then turn off the steam cleaner and remove the plug.
Wait approx. 45 minutes. Once the steam cleaner has
cooled down you can switch it on again.
Cleaning with the steam cleaner:
1. Push on the desired accessory, ZChapter 2.3, "Using
the accessories".
2. Pull the release button (Fig. 8/1) back and remove the
water tank (Fig. 8/2) from the back by tipping it.
Fig. 8
3. Unscrew the cover (Fig. 9/1) on the lower part of the wa-
ter tank.
1
4. Fill the water tank up with tap water and then screw the
lock down again.
NOTE:
The service life of the appliance can be extended by
using distilled water instead of tap water. This is recom-
mended particularly in those areas with hard water.
Fig. 9
ATTENTION:
Do not add anything to the water. This could destroy the
appliance.
5. Place the water tank inside again. First insert it by
putting the rear part into the holder body. Then press it
forwards (Fig. 10). The locking catch clicks audibly into
place.
6. Pull the cable attached to the plug (Fig. 1/19) out and
push the plug into the socket.
Fig. 10
7. Switch on the steam cleaner using the on/off switch
(Fig. 11/1). The indicator light (Fig. 11/2) lights up.
8. The steam cleaner now heats up for approx. 30 sec-
onds. Then the indicator light (Fig. 11/3) lights up sig-
nalling that it is ready for operation.
Fig. 11