KitchenAid KUDS01IL Guide De Référence page 13

Delay Hours
Select this option to run your dishwasher at a later time or during
off-peak hours. You can add items to the load anytime during the
delay countdown. After adding items, close the door firmly until it
latches. The delay countdown will not continue if the door is not
latched.
To delay the start (Model KUDS01IL)
You can delay the start of a cycle up to 24 hours.
The first time you select Delay Hours, you will see
showing a 1-hour delay.
1. Close the door.
2. Select a wash cycle and options.
3. Repeatedly press DELAY HOURS until you see the desired
hours of delay in the display.
When the delay reaches 24 hours, the delay turns off. Press
Delay Hours again to select a new number of delay hours.
NOTE: The delay is set at one-hour increments for the first
12 hours. The remaining delay hours are set at two-hour
increments.
4. Press Start.
NOTE: To cancel the delay, press Delay Hours until no delay hours
show in the display or press Start.
To delay the start (Model KUDS01DL)
1. Open the door.
2. Select a wash cycle and options.
3. Press 4 HOUR DELAY.
You will see
showing in the display.
4. Close the door.
5. Press the Start pad. The display will flash once to tell you that
the delay has started.
NOTE: To cancel the delay, press 4 HOUR DELAY to turn the light
off or press the Start pad.
To delay the start (Models KUDS01FL, KUDS01VM)
1. Open the door.
2. Select a wash cycle and options.
3. Press 4 HOUR DELAY. The delay light will glow.
4. Press START. The selected cycle and option will flash once to
tell you that the delay has started.
5. Close the door.
NOTE: To cancel the delay, press 4 HOUR DELAY to turn the light
off.
Status Indicators
Follow the progress of your dishwasher with the Status indicators.
Add Rinse Aid (on some models)
Fill the Rinse Aid dispenser when Add Rinse Aid is lit. A rinse aid
prevents water from forming droplets that can dry as spots or
streaks.
If the Rinse Aid dispenser is empty, the light glows when you
select a cycle or while a cycle is running.
Sensing/Soak (on some models)
Your dishwasher senses the soil level on the dishes. Soil level
determines the length of some cycles, the amount of heat or water
added, and the cycle needed for the load. Soaks help loosen soils
on the dishes.
Sensing/Soak glows during the sensing and soak parts of the
cycle. Wash action continues while sensing occurs. Wash action
pauses during a soak.
Add a Dish (on some models)
After a cycle starts, you can add an item to your dishwasher while
Add a Dish glows. After the light turns off, items added to the
dishwasher may not be completely cleaned.
Water Heating (on some models)
Water Heating glows, and the cycle progression pauses,
whenever water is heated to a set temperature during a cycle.
Wash or rinse action continues as the water heats.
Clean
Clean glows when a cycle is finished. The light turns off when you
open and close the door or press Cancel.
Sanitized
If you select the SANI RINSE™ option, Sanitized glows when the
SANI RINSE™ cycle is finished. If your dishwasher did not
properly sanitize your dishes, the light flashes at the end of the
cycle. This can happen if the cycle is interrupted or the incoming
water temperature is too low. The light goes off when you open
and close the door.
13