Mounting The Reamer En; Setting Up The Clamping Position En - Abicor Binzel BRS-CC Guide D'installation

6 Putting into operation
6.5 Mounting the reamer
1 Clamping device
Fig. 7 Mounting the reamer
NOTICE
• When changing the reamer, only use tools with a suitable width across flats.
1 Mount the reamer (2) along with the reamer seat.
2 Tighten the reamer (2) (min. 20 Nm).
6.6 Setting up the clamping position
1 Gas nozzle
Fig. 8 Setting up the clamping position
 Fig. 5 Putting into operation on page EN-12
1 Move the torch with the gas nozzle (1) vertically to the tool axis (reamer axis) over the BRS-CC (3) (P1).
2 Approach the clamping position (P2). Make sure that the cylindrical part of the gas nozzle (1) lies evenly
against the prism (2).
EN - 14
1
2 Reamer
Reamer seat AF 27 mm, reamer AF 17 mm.
1
2 Prism
2
3
3 Tool
2
3
3 BRS-CC maintenance station
BRS-CC