salmson SIE Série Notice De Montage Et De Mise En Service page 68

English
"Level higher" menu element
"Selection/setting" menu element
8.5.3 Display error page
Fig. 27: Error page (status in the event of
an error)
8.5.4 Menu groups
Basic menu
Info menu
Service menu
62
The "Level higher" menu element is indicated on the display by the
symbol shown here (arrow on the symbol display). If a "Level higher"
menu element is selected, briefly pressing the acknowledge button
causes a change to the next higher lower menu level. The new menu
level is labelled in the display by the menu number. For example, when
one returns from menu level <4.1.5.0>, the menu number jumps to
<4.1.0.0>.
NOTE
If the acknowledge button is pressed for 2 seconds while a "Level
higher" menu element is selected, the control jumps back to the sta-
tus display.
±
The "Selection/setting" menu element does not have a special label
on the display, but is indicated in the graphics of these instructions,
however, by the symbol shown.
If a "Selection/setting" menu element is selected, pressing the
acknowledge button will change to editing mode. In editing mode,
the value which can be changed by pressing a tuning button flashes.
In some menus, the acceptance of the input by pressing the acknowl-
edge button will be confirmed by the brief display of the "OK" symbol.
E000
If an error occurs, the error page will be shown in the display rather
than the status page. The value display shows the letter "E" and the
E.025
three-digit error code separated by a decimal point (Fig. 27).
Basic settings are shown in the main menus <1.0.0.0>, <2.0.0.0> and
<3.0.0.0> which provide access to set values which may have to be
changed during regular pump operation.
The main menu <4.0.0.0> and its submenu elements show measuring
data, device data, operating data and current states.
The main menu <5.0.0.0> and its submenu elements provide access to
fundamental system settings for commissioning. The sub-elements
are in a write-protected mode as long as service mode is not acti-
vated.
Caution – material damage!
Improper setting changes can lead to pump operation errors, which
can lead to material damage to the pump or system.
• Settings in service mode should only be done during commission-
ing and only by qualified personnel.
04/2009