General Information - TECNA 3680 Manuel D'utilisation Et De Maintenance

GENERAL INFORMATION

1
1.1 Purpose of the manual
This manual was created by TECNA s.p.a. to provide the
necessary information for the correct installation, use
and maintenance of the equipment.
The manual may at times refer to the equipment more
generically as the machine.
TECNA s.p.a. reserves the right to make any technical
changes to this manual and to the machine without
prior notice.
1.2 Warranty
1.2.1 Warranty period
TECNA s.p.a. guarantees its products against all factory
defects and undertakes to provide its customers with
free replacement of any parts found to have factory
defects.
1.2.2 Warranty period
TECNA s.p.a. guarantees its products for 24 months
from the date of delivery given on the purchase
document.
1.2.3 Warranty exclusions
The warranty does not cover components subject to
normal wear and tear, such as fuses, electrodes, cables,
flexible connections, hoses and nameplates.
1.3 Technical support requests
Our customer support/after-sales service is available
for clarifications and for dispatch of spare parts.
Always specify the following:
• Customer name and identification data.
• Equipment identification data.
• Purchase document
For any needs, please refer to:
TECNA S.P.A.
Via Meucci, 27
40024 Castel San Pietro Terme (Bologna) – Italy
Tel. +39.051.6954411
+39.051.6954490
E-mail service-professional@tecna.net
WARNING
The Customer must always purchase
original accessories and spare parts or
equivalents authorised in writing by
TECNA s.p.a.
Translated copy of the original Italian text
1.4 Nameplate
1.4.1
(See attached image A1)
The identification data for the manufacturer and the
machine are stamped on a nameplate.
The following data is displayed on the plate:
1. Identification of manufacturer.
2. CE conformity marking (only if applicable).
3. Spot welder code.
4. Spot welder version.
5. Spot welder serial number.
6. Year of manufacture.
7. Spot welder technical data.
8. Pneumatic gun code.
9. Pneumatic gun technical data.
10. Proper disposal of the product.
1.4.2 Pneumatic gun
(See attached image A2)
The identification data for the manufacturer and the
pneumatic are stamped on an identification plate.
The following data is displayed on the plate:
11. Identification of manufacturer.
12. Pneumatic gun code.
13. Supply voltage of the machine to which the gun
can be connected.
14. Proper disposal of the product.
– Fax
EN-1
WARNING
It is prohibited to tamper with, engrave,
alter or remove the machine nameplate.
WARNING
In the event of accidental damage to one
or more nameplates, the incident should
be reported immediately to TECNA s.p.a.
Spot welder
EN