Husqvarna DT600 Manuel D'utilisation page 5

• Observe your surroundings and make sure that there
is no risk of people or animals coming in contact with
or affect your control of the product.
• Listen out for warning signals or shouts when you
are wearing hearing protection. Always remove your
hearing protection as soon as the engine/motor
stops.
• Do not use the machine in bad weather, such as
dense fog, heavy rain, strong wind, intense cold, etc.
Working in bad weather is tiring and often brings
added risks, such as icy ground.
• Make sure you can move and stand safely. Check
the area around you for possible obstacles (roots,
rocks, branches, ditches, etc.) in case you have to
move suddenly. Take great care when working on
sloping ground.
• The engine/motor must be switched off before
moving.
• Never put the machine down with the engine/motor
running unless you have it in clear sight.
• Always use both hands to hold the machine. Hold
the machine at the side of your body.
• Make sure hands and feet do not come near the
moss dethatcher when it is running.
• When the engine/motor is switched off, keep your
hands and feet away from the moss dethatcher until
it has stopped completely.
• If heavy vibration occurs, stop the machine. If you
have a gasoline operated product, disconnect the HT
lead from the spark plug. If you have a battery
operated product, remove the battery from the
product. Make sure that the machine is not
damaged. Repair any damage.
Personal protective equipment
WARNING:
instructions that follow before you use the
product.
• Always use approved personal protective equipment
when you use the product. Personal protective
equipment cannot fully prevent injury but it
decreases the degree of injury if an accident does
occur. Let your dealer help you select the right
equipment.
743 - 005 - 07.04.2021
Read the warning
• Use approved hearing protection that provides
adequate noise reduction. Long-term exposure to
noise can result in permanent hearing impairment.
• Use approved eye protection. If you use a visor, you
must also use approved protective goggles.
Approved protective goggles must comply with the
ANSI Z87.1 standard in the USAs or EN 166 in EU
countries.
• Use gloves when necessary, for example when you
attach, examine or clean the cutting equipment.
• Use protective boots with steel toes and non-slip
soles.
• Use clothing made of a strong fabric. Always use
heavy, long pants and long sleeves. Do not use
loose clothing that can catch on twigs and branches.
Do not wear jewelry, short pants, sandals or go with
bare feet. Put your hair up safely above shoulder
level.
5