Setting The Wireless Display - Panasonic CF-VDW07BH Mode D'emploi

Setting the Wireless Display

You can establish the settings for the wireless display.
Press Menu button.
The setting menus are displayed.
General Menu
By selecting [General], you can change the mode setting, the backlight setting and the
profile setting.
Default settings
General Wireless Battery
Mode : Connect
Backlight : LOW
Profile : Profile 1
100% Excellent
Wireless Menu
By selecting [Wireless], the wireless settings (for connection with the computer) and
current state are displayed (cannot be changed). To change the settings shown on this
menu: page 35
General Wireless Battery
Network Type : AdHoc
SSID : cfvdw07-17498
Channel : 11
TxRate mode : Fully Automatic
WEP Encryption : disable
Rate (Tx/Rx) : 11Mbps / 11Mbps
Display IP : 10. 98. 185. 106
PC IP : 10. 98. 185. 105
Net Mask : 255.
AES Encryption : disable
100% Excellent
Option Version
OfflineView
MID HIGH
OK Cancel
Option Version
0. 0. 0
OK Cancel
This screen is a sample.
Menu Button
The saved screen is displayed.
( page 38)
The profile name will be displayed.
When setting a profile, a wireless
display can be connected to an-
other computer. Up to four profiles
can be set. ( page 33)
After selecting the profile, select
[Connect], and the connection will
be taken place using the profile.
Electronic wave conditions (Excel-
lent, Good, Poor, Associated, Scan-
ning)
Remaining battery charge
The display will indicate whether
AES Encryption is set to be en-
abled or disabled.
E
31