Table des Matières
Publicité
•
All holes should be sealed with silicone or foam.
•
Check with a sheet of paper that the fans blow in the right direction.
•
The drain circuit should be slanted on all evaporators and the moisture trap
shoul be installed.
•
The hole should be located at the expansion valve on all evaporators.
•
The temperature sensor should be connected on all evaporators.
•
The in-cab control box should be located in a spot that it is accessible and
visible from the driver's position.
(Rev. 3, 05/10)
Checking the Installation
•
The contact draw should be made.
•
Hoses should not be taut (they should be able to absorb vibrations and be
shortened in case of leaks).
•
Hoses should not rub against moving parts, sharp parts, or parts that can reach
high temperatures.
•
The unit should be connected to the battery.
•
The seal test should have been carried out.
Eng
42
Publicité
Chapitres
Table des Matières
