Squeegee Replacement; Troubleshooting - Nilfisk CA 340 Manuel D'emploi Et D'entretien

SQUEEGEE REPLACEMENT

If the squeegee leaves narrow streaks of water, it is
probably dirty or damaged.
Remove the squeegee, rinse it with clean water and
inspect the squeegee rubbers.
Reverse or replace the squeegee rubber if it is cut, torn,
wavy or worn.
To Reverse or Replace the Squeegee Rubber:
1. Unplug machine.
2. Remove tanks.
3. Tilt machine backwards.
4. Remove the two screws at nozzle.
5. Take out nozzle and change squeegees.
08603372(3)2004-05 A
USE AND MAINTENANCE MANUAL

TROUBLESHOOTING

TROUBLE
There is no power. Motors do
not work
Brush motor does not work,
brush does not turn
Inadequate suction
Poor cleaning
REMEDY
Check plug and cable
Check main fuse
Defective switch on operating
panel
Defective drive belt
Brush not fixed
Worn or defective squeegees
Clogged suction inlet
Defective suction hose loose
Defective tank lid
Jammed float valve
Dirty turbine pre-filters
Worn brush
Too soft brush
Work at a lower speed
Clogged water supply
Clogged solution filter
5