Maintenance - Thermor SSC NF 3 Etoiles Oeil Notice D'utilisation

- Perform the following checks to ensure that the programming commands
are correctly transmitted:
Received
commands
0 volt
230 V 3 s/5 min
230V 7 s/5 min
230 V
- 115 V negative
+ 115 V positive
- The frost protection or load shedding commands have priority in terms
of pilot wire or carrier current programming.
- There is a delay of around 12 seconds for switching between Comfort
and Eco mode.
- The delay for switching between Comfort -1/-2 to Comfort mode is
around 5 minutes.
Ensure that all electrical power supplies have been cut off before
maintenance work
on the appliance. The appliance must be dusted twice a year to ensure its
performance is maintained.
Never use abrasive products and solvents.
Oscilloscope Ref/
Neutral

MAINTENANCE

26
Mode obtained
COMFORT
COMFORT - 1° C
COMFORT – 2° C
ECO
FROST PROTECTION
HEATING OFF