Troubleshooting - SilverCrest SBF 77 Instructions D'utilisation Et Consignes De Sécurité

- If the weight increases in the medium term
and the body fat percentage decreases or
remains steady, on the other hand, you may
have built important muscle mass.
- If the weight and body fat percentage de-
crease at the same time, your diet is working
– you are losing fat.
- Your diet will ideally be accompanied with
physical activity, fitness or weight training. You
can then increase your muscle mass in the
medium term.
- However, do not add body fat and water per-
centages or muscle mass (muscle tissue also
contains water).

Troubleshooting

= Error/Display
= Cause
= Solution
= The LC-display
1
= Unknown value - outside the user assignment
limit or unable to clearly identify a user.
= Select your user by pressing the buttons
and
.
4
= The LC-display
1
= The fat percentage is outside the measurable
range (less than 3 % or higher than 65 %).
= Repeat the measurement barefoot, if neces-
sary dampen the bottoms of your feet.
= The LC-display
1
= The maximum load capacity of
180 kg / 396lb / 28 st has been exceeded.
= Do not exceed 180 kg / 396 lb / 28 st.
= The incorrect weight is displayed.
= The surface is not level or firm.
= Place the scales on a level, firm surface.
= You are not standing still.
= Stand as still as possible.
reads "- - -".
2
shows "BF-Err".
reads "Err".
= The incorrect weight appears.
= The zero point of the scales is incorrect.
= Wait for the diagnostic scales to shut off auto-
matically. Activate the diagnostic scales, wait
for "0.0 kg" to appear, then repeat the meas-
urement.
= No Bluetooth connection (
®
not appear).
= Device out of range.
= The open area minimum range is approx. 10 m.
Walls and ceiling reduce this range. Other
radio waves can interfere with transmission.
Therefore do not place the diagnostic scales
near devices such as WiFi router, microwave,
induction hobs.
= No Bluetooth connection (no
®
symbol).
= Not connected to the app.
= Completely close the app (including in the
background).
Restart Bluetooth
® .
Please note that the scales must not be con-
nected from the operating system Bluetooth
settings. If necessary, remove from the devices
list in the Bluetooth settings, and then use the
®
"HealthForYou" app.
Restart the smartphone.
Briefly remove and reinsert the batteries in the
scales.
= The LC-display
1
flashing synchronisation symbol
= The user memory is full. Old measurements
will be overwritten by new measurements.
= Open the app within Bluetooth
The data will automatically be transferred. This
may take up to a minute.
= The LC-display
1
= The batteries in the diagnostic scales are dead.
= Replace the batteries.
does
21
®
is showing a
.
20
range.
®
reads "Lo".
GB/IE 33