Electrical Safety - Bosch ART 24 Notice Originale

OBJ_BUCH-1983-006.book Page 11 Thursday, September 22, 2016 9:42 AM

Take care against injury from the
blade fitted for cutting the nylon line
length. After feeding line always re-
turn the trimmer to its horizontal op-
erating position before switching on.
 Switch off and remove the plug from
the socket:
– whenever you leave the machine
unattended for any period
– before replacing the spool
– before cleaning or working on the
trimmer

After use, disconnect the machine
from the mains and check for dam-
age.
 Store the machine in a secure, dry
place out of the reach of children. Do
not place other objects on top of the
machine.
 Replace worn or damaged parts for
safety.

Ensure replacement parts fitted are
Bosch approved.
 Do not operate the machine with-
out the trimmer attachment fitted.

Electrical Safety

 Warning! Switch off, remove plug
from mains before adjusting,
cleaning or if cable is cut, damaged
or entangled.

The cutting line continues to rotate
for a few seconds after the trimmer
is switched off.
 Caution – do not touch rotating
cutting line.
Your machine is double insulated for
safety and requires no earth connec-
tion. The operating voltage is 230 V AC,
50 Hz (for non-EU countries 220 V,
Bosch Power Tools
240 V as applicable). Only use ap-
proved extension cables. Contact your
Bosch Service Centre for details.
It is recommended for increased
electrical safety to use a Residual
Current Device (RCD) with a tripping
current of not more than 30 mA. Al-
ways check your RCD every time you
use it.
For products not sold in GB:
WARNING: For your safety, it is re-
quired that the plug attached to the ma-
chine is connected with the extension
cord. The coupling of the extension
cord must be protected against splash
water, be made of rubber or coated
with rubber. The extension cord must
be used with a cable strain relief.
The connection lead must be inspected
for signs of damage at regular intervals
and may only be used if in perfect con-
dition.
If the supply cord is damaged, it must
be replaced by a Bosch Service Centre.
Extension cords should only be used if
they comply with H05VV-F or H05RN-F
types.
 Products sold in GB only: Your prod-
uct is fitted with a BS 1363/A ap-
proved electric plug with internal fuse
(ASTA approved to BS 1362).
If the plug is not suitable for your
socket outlets, it should be cut off
and an appropriate plug fitted in its
place by an authorised customer ser-
vice agent. The replacement plug
should have the same fuse rating as
the original plug.
F 016 L81 619 | (22.9.16)
English | 11