Electrical Safety - Bosch AFS 23-37 Notice Originale

Ensure replacement parts fitted are
u
Bosch-approved.
Have the product repaired only by an
u
authorized Bosch customer service
agent.
Before storing, make sure that the
u
product is clean and free of residue.
If necessary, clean with a soft dry
brush.
Any blockages between the cutting
u
head and guard should be removed.
For compact storage, the product
can be separated at the shaft.

Electrical Safety

Warning! Switch the
product off and pull the
mains plug before any main-
tenance or cleaning. The same ap-
plies when the mains cable is dam-
aged, cut or entangled.
Your product is double insulated for
safety and requires no earth connec-
tion. The operating voltage is 230 V
AC, 50 Hz (for non-EU countries
220 V, 240 V as applicable). Contact
your Bosch Service Centre for details.
If in doubt contact a qualified electri-
cian or the nearest Bosch Service
Centre.
For increased electrical safety use a
Residual Current Device (RCD) with a
tripping current of not more than
30 mA. Always check your RCD every
time you use it.
Keep the supply cables away from
moving hazardous parts and avoid
Bosch Power Tools
damage to the cables; this can lead to
contact with live parts.
The connections (plugs and sockets)
should be kept dry and off the ground.
The supply cables must be inspected
for signs of damage at regular intervals
and may only be used if in perfect con-
dition.
If the supply cable on the product is
damaged, it must only be replaced by
a Bosch Service Centre. Only use ap-
proved extension cables.
Use only extension cords, cables,
leads, cable reels that comply with EN
61242/IEC 61242 or IEC 60884-2-7.
If you want to use an extension cable
when operating your product, only the
following cable dimensions should be
used:
– Nominal conductor area of
2
1.25 mm or 1.5 mm
– Maximum extension cord length
30 m or 60 m for a cable reel with
Residual Current Device (RCD).
Note: If an extension cable is used it
must be earthed and connected
through the plug to the earth cable of
your supply network in accordance
with prescribed safety regulations.
If in doubt contact a qualified electri-
cian or the nearest Bosch Service
Centre.
WARNING! Inadequate ex-
tension cables can be dan-
gerous. Extension cable,
plug and socket must be of water-
English | 15
2
F 016 L81 886 | (19.02.2019)