Maintenance And Service; Emptying The Waste Bin; Lubricating The Cutting Mechanism; Cleaning The Device - Olympia ECS 408.2 CCD Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28
9

Maintenance and Service

Maintenance work may only be completed when the power plug has been
Attention:
disconnected from the power socket!
9.1

Emptying the waste bin

The waste bin must be emptied when the red "Waste bin full" lamp lights up at the latest.
1. Set the On/Off switch to its OFF position.
2. Pull the waste bin to the front and out of the device.
3. Empty the contents according to waste disposal requirements.
4. Slide the waste bin back in the device.
It is recommended not to allow the waste bin to fill up against the cutting
Note:
mechanism. This prevents the shredded paper congesting and jamming in
the cutting mechanism. Empty the waste bin regularly.
When the waste bin is removed from the device, the shredder cannot be
Note:
used. The shredder only operates when the original waste bin is inserted
correctly.
9.2

Lubricating the cutting mechanism

To ensure a long service life for your paper shredder, we recommend clearing any
residue from the cutting mechanism regularly and applying a little special oil for paper
shredders on the cutting tool. You can obtain the special CFC-free oil from your supplier
or directly from our service centre in Hattingen. This helps lengthen the service life of the
device.
Each time the waste bin is emptied, apply several lines of the special oil in a lateral
direction on a suitable sheet of paper and feed this sheet through the shredder when
the ECS function is set.
It is forbidden to use oil spray from aerosol cans containing CFC!
Attention:
9.3

Cleaning the device

Safety note:
1. Set the On/Off switch to its OFF position and disconnect the power plug from the
power socket.
2. Clean the outside of the device with a soft, slightly damp cloth.
In order to clean the housing, do not use any aggressive, common house-
Note:
hold cleaning agents or any chemicals (e.g. solvents, petroleum ether). If
necessary, only use cleaning products specifically approved for cleaning
shredders.
It is forbidden to used easily inflammable substances. Risk
of injury!
23

Publicité

Table des Matières
loading

Table des Matières