Olympia ECS 408.2 CCD Mode D'emploi page 20

5 Operation
The recommended capacities stipulated in Chapter "Technical Data" must
Note:
not be exceeded, otherwise material will jam! Do not forget that the thick-
ness of the paper increases when folded, as a result of which the recom-
mended sheet capacity can be exceeded. Also reduce the quantity of pa-
per when shredding coarse paper.
5.1 Switching the device on
Set the On/Off switch to its ON position.
●
The green "power on" lamp lights up.
The device is ready to operate.
5.2 ECS function (automatic EcoShred operation)
2
When the ECS function is activated, the shredding operation of the cutting mechanism
starts up automatically as soon as material is inserted in the respective infeed slot:
The device switches to forward drive and draws the material in.
●
5 seconds after shredding is finished, the device switches off automatically.
●
The ECS function is activated by pressing the ECS button. The ECS button then lights up
blue.
When the ECS function is activated, paper can be shredded via the paper
Note:
infeed and CDs, DVDs and credit cards shredded via the CD infeed. Only
one infeed may be used at a time. If you use more than one infeed, the
device stops. Pay attention to the permissible quantity of material which
can be shredded.
When the ECS function is activated, the device has a very low power con-
Note:
sumption.
5.3 Shredding paper
A maximum of 8 sheets of A4 paper with a weight of maximally 70 g/m
Note:
may be inserted in the paper infeed at a time.
Remove any other material from the paper, such as paper clips or labels.
Note:
1. The device is switched on and the ECS function is activated.
2. Insert paper in the paper infeed.
2
Abbreviation for EcoShred
20
2