Olympia ECS 408.2 CCD Mode D'emploi page 19

4 Starting Up
1. Remove the device carefully from the packaging.
The underside of the cutting mechanism attachment has sharp edges. Risk
Attention:
of injury!
2. Place the device on a level surface.
3. Position the device near a power socket. However, do not position it near a source of
heat or water.
4. Insert the waste bin.
The shredder only operates when the original waste bin is inserted cor-
Note:
rectly.
5. Set the On/Off switch to its OFF position.
6. Connect the power plug to a power socket.
Pay attention that the power cable is laid so that people or pets do not walk
Note:
over it or that other objects can be set down on it.
Pay attention to the information regarding power supply on the rear side of
the device for the necessary precautions.
Safety information:
For reasons of safety, the power socket to which the
shredder power plug is connected must be near to the
device and freely accessible so that the power supply
can be disconnected quickly in an emergency!
19