Télécharger Imprimer la page

Descaling The Appliance - SilverCrest SEM 1100 B3 Mode D'emploi

Masquer les pouces Voir aussi pour SEM 1100 B3:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 52

Descaling the appliance

CAUTION! PROPERTY DAMAGE!
Do not generate steam when the descaler solution is in the water tank
Descale the appliance regularly. The appliance should be descaled after about
1–2 months (if used to make approx. 4 espressos per day). This value can vary
depending on the hardness of the water in your region.
Proceed as follows to use the descaler
1) Add the descaler
2) Fill the water tank
in the appliance.
3) Switch on the appliance using the On/Off switch
steam control
4) Insert the sieve holder
5) Place 2 cups or a container capable of holding at least 250 ml under the
sieve holder openings.
6) As soon as the green heating-up control lamp
"Espresso" button
Allow around 250 ml (around 2 cups) of descaler solution to run through
and then stop the process by pressing the "Espresso" button
Carefully pour out the used descaler solution.
7) Allow the descaler
8) Repeat steps 6 to 7 three more times. Empty the water tank
the last time.
9) Place a sufficiently large container (at least 1 litre) under the sieve holder
openings.
10) Rinse out the water tank
the Max mark.
11) As soon as the green heating-up control lamp
"Espresso" button
Allow the water to run through completely. Carefully pour out this water.
12) Repeat steps 10 to 11 once and then turn off the appliance.
13) After descaling, wipe off the appliance with a damp cloth to remove any
splashes of the descaler solution. Ensure that the appliance is completely dry
before the next use.
You can order more descaler
replacement parts").
We recommend using the descaler
also use other commercially available descaling agents for espresso machines.
If you do so, proceed as described in the operating instructions of the respective
descaler.
SEM 1100 B3
supplied with the appliance:
(125 ml) to the water tank
up to the Max mark with water and replace the tank
is shut off.
without any espresso sieve
so that it clicks into place.
to act for approx. 1 minute.
with fresh water and fill it with fresh water up to
so that it clicks into place.
via our customer service (see section "Ordering
supplied with the appliance. You can
.
. Make sure the
into the appliance.
lights up, push in the
again.
completely
lights up, push down the
GB │ IE
 43
!

Publicité

loading