Publicité
10 von 26
Parts included
Quantity Mat. no.
Designation
1
EZL 235 electronic
4
Standoff
1
MFM 2-5 coding plug
1
"1N1-16, 2N1-16 L, N" wiring harness
1
"1N1-16, 2N1-16 bus" wiring harness
3
Brown connecting wire, 90mm
1
Blue 6-pin screw-terminal strip
1
Green 7-pin screw-terminal strip
1
Orange/gray terminal strip 3X3-4
1
Blue/green/yellow terminal strip 3X3-4
1
Accessory module
1
Module mounting bracket
2
Fixing bracket for module mounting bracket
4
Raised-head screws, CEM 6 x 12
6
M12 cord connector
6
M20 cord connector
1
Wiring diagram
Danger due to incorrectly carried out service and repair work
WARNING
Danger due to incorrectly carried out service and repair work.
There is a risk of serious damage, injury and even death if service and repair work is carried out incorrectly.
A
Service and repair work should only be carried out by a suitably qualified electrician with specialist training,
knowledge and experience.
A
All appropriate safety regulations must be taken into account.
A
Read the technical service documentation (TSD) before starting service work.
Risk of cuts
CAUTION
Components are sharp.
Risk of cuts.
A
Protective gloves should be worn and the edge protection, mat. no. 05057680, should be used.
Installing module 2 for liquid dispensing 7-12
A
Remove the machine lid; see the model-specific TSD.
A
Install the module mounting bracket (3) with fixing brackets (4) onto the crossbar. See Fig. 1.
A
Secure the module (1) with standoffs (2) onto the mounting bracket (3). See Fig. 1.
A
Install the terminal strips (5) in the pre-punched holes on the crossbar. See Fig. 1.
A
Secure cable screw connectors (1) to the top of the rear panel. To do this, push the appropriate pre-punched holes
out of the top of the rear panel; see Fig. 2.
A
Connect the green 7-pin screw-terminal strip to plug ST8 on the module; see Fig. 3.
A
Connect the green 6-pin screw-terminal strip to plug ST12 on the module; see Fig. 3.
16.03.2018
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 10717761
Publicité
